Here are my Hyper-fast Active foaming Light Weight PLA settings.  These are designed for Bambu Lab printers specifically the P1P, P1S, X1C, X1E, and H2D printers.  You may find they also work on similar printers such as the Prusa XL.

Filament settings

Buy today at: https://cults3d.com/en/3d-model/gadget/f7u-cutlass-50mm-edf-jet

Buy it today at: https://cults3d.com/en/3d-model/gadget/nasa-x-36-50mm-edf-jet

Buy today at: https://cults3d.com/en/3d-model/gadget/f4d-skyray-50mm-edf-jet

You'd be hard pressed to find another edf Jet easier to fly, foam (purchased) or 3d printed. This is 100% the easiest EDF jet to fly I've flow or seen fly on youtube. It prints fantastic and it assembles easily. This Skyray hand launches super easy and will fly at 1/2 throttle and land like butter. Like I said, this can be an EDF trainer or it can be a fun fast aerobatic jet.

https://www.facebook.com/groups/384918717530863 Kyle's Designs main facebook group.  This is the best place for news, support, questions, and comments.

Buy today at: https://cults3d.com/en/3d-model/gadget/shmiggen-50mm-and-64mm-edf-jets-cartoon-viggen

well... this ones special. Super special. It flies amazing as you can see from my videos. I'm offering this jet as a double pack. 50mm and 64mm. I would challenge any 3d printed jet designer to compete against this little fatty. 
Pros:
1. looks funny and cute
2. flies unbelievably slow (cartoon planes never do)
3. tons of control, you can perform almost every stunt

Buy today at: https://cults3d.com/en/3d-model/gadget/yf-23-black-widow-twin-50mm-edf

Buy today at: https://cults3d.com/en/3d-model/gadget/cartoon-mirage-2000-50mm-edf

I was genuinely surprised at how well this flew on its maiden flight. It was literally perfect. The only thing i had to adjust was the roll rate. This jet prints extremely easy and can be built in 1 hour!!

plane is 22" long and 20" wide. You can print this on a 220/220/220 build plate

parts used 
Power fun 50mm 4s
1300-1500 4s recommended. 2200 4s can work fine just a little heavier
velcro
assorted magnets 
2x 9G MG servos

Buy today at: https://cults3d.com/en/3d-model/gadget/t-7-50mm-edf-jet-trainer

Buy today at: https://cults3d.com/en/3d-model/gadget/j10-50mm-edf

This is the same design as my 64mm with modifications to the scale for the 50mm xfly EDF and also reworked servo pockets for 9g servos. It flies exactly the same as my 64mm but it lands way softer.

This jet is only 595g FLYING WEIGHT with a 4s 1300!

32" long
19" wingspan

super easy construction video

https://youtu.be/7neU2yfb3Ho?si=gO_eFSUMTZ5cB4-t